ROLEX JUBILEE WATCH BAND INSTRUCTION VIDEOS

How To Remove Links

This video shows how to remove the links of a Bandini jubilee watch band for Rolex. Below are the steps.

Before starting, make sure you have a 1.0mm flathead screwdriver

Step 1: Locate screws on the side of the jubilee watch band.

Step 2: Using a 1.0mm flathead screwdriver, unscrew the link next to link you want to remove.

Step 3: Pull out the pin and separate the band.

Step 4: Unscrew the link that you want to remove and take it off.

Step 5: Reconnect the band

Step 6: Insert the screw and screw the band back together. *Note: you might need to jiggle the band a bit for the screw to slide in fully*

How to Install the Curved Ends

This video shows how to switch from the straight end to the curved ends of a Bandini jubilee watch band for Rolex. Below are the steps.

Before starting, make sure you have the link removal tool and the two 20mm spring bar pushpins that were included with your Bandini Jubilee watch band.

Step 1: Locate pin on the side of the straight end.

Step 2: Loosen the link removal tool.

Step 3: Place the band in the link removal tool and align the pin on the side of the straight end with the pusher. Once done, start to push out the pin by retightening the tool. (The pin should be easy to push out, if there is resistance, stop and realign the tool)

Step 4: Once the pin is halfway out, loosen the link removal tool, pull out the pin and remove the straight end link.

Step 5: Place curved end in bracelet and insert a 20mm spring pushpin.

Step 6: Repeat Steps 1 through 5 on the other end of the band.

*NOTE: The curved end will not hold tightly until it is connected to the watch. Before that it will still be loose.